| Pirelli LP-D10 GSM/VoiP Phone with Tpad |
| |
 |
This guide covers: |
- Setting up your Tpad account on the Pirelli LP-D10
- Making Calls with Tpad
- on configuring your Wireless LAN access point on the LP-D10
|
| |
| Setting up your Tpad account on the Pirelli LP-D10 |
| |
Press Menu > WLAN > SIP Settings.
To configure the phone with Tpad you need to define the following settings in the SIP Settings menu: |
| |
| Username |
Your Tpad phone number e.g. 1123444 |
| Password |
Your Tpad account password. |
| Auth. name |
Your Tpad phone number e.g.1123444. |
| Domain name |
Enter sip.tpad.com |
| Local port |
Enter 5060. |
| Proxy server |
Enter sip.tpad.com. |
| Proxy port |
Enter 5060 |
| Register server |
Enter sip.tpad.com. |
| Register port |
Enter 5060 |
| Register period |
Enter 3600 |
| Outbound server |
Enter sip.tpad.com |
| Outbound port |
Enter 5060 |
| RTP audio port |
Enter 9000 |
| RTP pkt.period |
Enter 20 |
| Preferred codec |
Select G.711A |
|
| |
| Press back three times to return to the home screen |
| |
|
| |
To make a normal GSM phone call when Tpad is not active, key in the phone number, including the area code and press the Green key to call the number. Press the Red key to end a call or to cancel the call attempt .
When Tpad Mode is active, the next outgoing call will go out via Tpad by default.
You can press the Left soft key > Options to select whether to send the call by GSM or Tpad WLAN |
| |
|
| |
Configuring your Wireless LAN access point on the LP-D10 |
|
|
| |
| Select WLAN Profile |
Before you set the access to WLAN network, select a profile, and check if the profile is set and active. |
| |
| 1. Press Menu > WLAN > WLAN Settings > Active Settings |
| |
Choose an appropriate profile:
Home: when you set a WLAN in house, use this profile and save the
Home WLAN info.
Office: when you set a WLAN in office, use this profile and save the
Office-WLAN info.
Hotspot: Set the WLAN in the Hotspot when you have the operator of the
Hotspot. |
| |
| Define your WLAN access point |
| |
Set SSID by site survey
Press Menu > WLAN > WLAN settings > Edit act. settings > SSID &
security > SSID > Site survey. The display shows a list of all APs which
are found nearby with good signal strength.
Select your WLAN access points AP’s SSID
Set SSID manually
Press Menu > WLAN > WLAN settings > Edit act. settings > SSID &
security > SSID > Manual. Input SSID in the SSID edit window.
- Security Setting: for WLAN encryption:
Set security
1. Press Menu > WLAN > WLAN settings > Edit act. settings > SSID &
security > SSID > Security. The display shows the security items to be
set.
Open := It sets no encryption.
WEP := WEP encryption, for WEP key settings. The key must be entered in hexadecimal or ASCII format: A-F and 0-9. On the right top corner, a counter decrements and reaches zero as all characters have been entered |
| |
